Advertisement
Specifications
This table lists specifications for the power injectors:
Specification
Electrical
Connectors
Dimensions (L, W, H)
Stacking restrictions
Mechanicals
Regulatory Information
The following information is for FCC compliance of Class B devices:
The equipment described in this manual generates and may radiate radio-frequency energy. If it is not
installed in accordance with Cisco's installation instructions, it may cause interference with radio and
television reception. This equipment has been tested and found to comply with the limits for a Class B
digital device in accordance with the specifications in part 15 of the FCC rules. These specifications are
designed to provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation.
Modifying the equipment without Cisco's written authorization may result in the equipment no longer
complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use
the equipment may be limited by FCC regulations, and you may be required to correct any interference
to radio or television communications at your own expense.
You can determine whether your equipment is causing interference by turning it off. If the interference
stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment
causes interference to radio or television reception, try to correct the interference by using one or more
of the following measures:
AIR-PWRINJ5=
802.3af compliant 15.4 W power
2 RJ-45 10/100/1000 (Cat 5 or better Ethernet cable)
165 mm x 65 mm x 36 mm (6.5 in x 2.6 in x 1.4 in)
Do not stack. Do not bundle the power injector and AC
power cable.
Cisco Aironet Power Injector (AIR-PWRINJ5) Installation Guide
Specifications
5
Advertisement
