Table of Contents
Advertisement
show environment Commands
The show environment command display reports the current environmental status of the system.
The report displays parameters that are out of the normal values. No parameters are displayed if the
system status is normal. The example that follows shows the display for a system in which all
monitored parameters are within Normal range. Following is sample output of the show env
command:
Router# show env
All measured values are normal
If the environmental status is not normal, the system reports the worst-case status level in the last
line of the display.
The show environment table command displays the temperature and voltage thresholds for each of
the three RSP2 temperature sensors, for each monitored status level: low critical, low warning, high
warning, and high critical. The slots in which the RSP2 can be installed are indicated in parentheses
(6 and 7). Also listed are the shutdown thresholds for the processor boards and power supplies.
Following is sample output of the show env table command:
Router# show env table
Sample Point
RSP(6) Inlet
RSP(6) Hotpoint
RSP(6) Exhaust
RSP(7) Inlet
RSP(7) Hotpoint
RSP(7) Exhaust
+12 Voltage
+5 Voltage
-12 Voltage
+24 Voltage
Shutdown boards at
Shutdown power supplies at
Note
LowCritical
10.76
4.49
-10.15
19.06
Temperature ranges and values are subject to change.
LowWarning
HighWarning
101C/213F
101C/213F
101C/213F
101C/213F
101C/213F
101C/213F
11.37
12.64
4.74
5.25
-10.76
-13.25
21.51
26.51
101C/213F
101C/213F
Cisco 7513 Blower Module Assembly Replacement Instructions
show environment Commands
HighCritical
101C/213F
101C/213F
101C/213F
101C/213F
101C/213F
101C/213F
13.24
5.52
-13.86
28.87
7
Advertisement
Table of Contents
