Table of Contents
Advertisement
1 CTR controller (4 Token Ring).
Environmental Controller.
8 Ethernet/IEEE 802.3 interface.
4 Token Ring/IEEE 802.5 interface.
2 Serial network interface.
1 HSSI network interface.
1 FDDI network interface.
You can display a description of the current ciscoBus controller card with the show controller cbus
EXEC command. The ciscoBus controller type is displayed, followed by a description of each
ciscoBus interface card, the ciscoBus slot in which it is installed, and the microcode version of each.
A sample of the display follows. For complete descriptions of all of the displayed fields, refer to the
Router Products Configuration Guide and Router Products Command Reference publications. In the
following display, note that the microcode version on all ciscoBus interface cards is Version 10.0 or
later, indicating that the ciscoBus controller is a CSC-CCTL2.
router# show cont cbus
ciscoBus 1, controller type 6.0, microcode version 10.0
512 Kbytes of main memory, 128 Kbytes cache memory
(display text omitted)
FDDI-T 0, controller type 7.1, microcode version 10.1
Interface 0 - Fddi0, station address 0000.0c02.6aa3
(display text omitted)
CTR 1, controller type 9.0, microcode version 10.1
Interface 8 - TokenRing0, station address 0000.3040.e004
13 buffer RX queue threshold, 31 buffer TX queue limit,
(display text omitted)
Interface 9 - TokenRing1, station address 0000.3040.e084
(display text omitted)
Interface 10 - TokenRing2, station address 0000.3040.e044
(display text omitted)
Interface 11 - TokenRing3, station address 0000.3040.e0c4
(display text omitted)
HSCI 2, controller type 10.0, microcode version 10.0
Interface 16 - Hssi0, electrical interface is Hssi DTE
(display text omitted)
You can display a description of the current Multibus Token Ring interfaces with the show
controller token command. There is no card name or controller type displayed with this command.
Although it is not apparent, the card type is distinguishable in the first line of the show controller
token display (CSC-1R/2Rs are displayed as TR Unit n on the first line of the display; CSC-R16Ms
are labeled TRn in the first line.) The microcode version (labeled f/w ver) is displayed on about the
twelfth line of the display.
The following example shows a CSC-1R with Microcode Version 1.2 installed:
router# show cont token
TR Unit 0 is board 0 - ring 0
(11 lines of text omitted)
f/w ver: 1.2 expr 0, chip f/w:00000.ME31100,[bridge capable]
SMT versions: 1.01 kernel, 4.02 fastmac
(text omitted)
The following example shows a CSC-R16M with Microcode Version 3.2:
router# show cont token
TR0: state 3, dev blk: 0x1C98A4, mailbox: 0x21000B0, sca: 0x2010000
(11 lines of text omitted)
f/w ver: 3.2, chip f/w: '000000.ME31100', [bridge capable]
ciscoBus Token Ring Card and Applique Installation and Upgrade Instructions
Installation Prerequisites
7
Advertisement
Table of Contents
