Honeywell E-Mon IDR Series Installation Instructions Manual page 6

E-MON INTERVAL DATA RECORDER
2.0 MECHANICAL INSTALLATION
IMPORTANT:
The internal circuits of the IDR can be damaged by electrostatic discharge. Before reaching inside the
enclosure, discharge yourself by touching an earth-grounded object.
Accidental discharge of static electricity onto the circuit board can result in:
- Loss of stored data
- A system lock-up
- Permanent damage to the IDR
The IDR is available in two types of enclosure systems:
1. Stand-Alone IDR (Standard Configuration).
The stand-alone IDR configuration consists of a single IDR unit. The enclosure should be mounted using
the mounting flanges located at the top and bottom of the enclosure. The enclosure has three available
knockouts for cable entrance/ exit from the IDR.
NEVER ATTEMPT TO DRILL THROUGH THE STEEL ENCLOSURE. DOING SO MAY PERMANENTLY
DAMAGE THE ELECTRONIC CIRCUITRY AND WILL VOID ALL WARRANTIES.
2. MMU (Multiple Meter Unit) Configuration.
MMU units containing Honeywell E-Mon meters and IDRs have been pre-wired by the factory prior to
shipment. The meters have been connected to the IDR. The installer needs to provide 120V power for the
IDR unit in the MMU. See Section 6.0 for communication connections.
62-0394—06
Fig. 3. JIC Steel Enclosure.
6