Electronic Function - Makita HP001G Instruction Manual

Torque level 22
Machine screw
Wood Soft
screw wood
(e.g.
pine)
Hard
wood
(e.g.
lauan)
High speed
Torque level 1
Machine screw M4
Wood Soft ø3.5
screw wood x 22
(e.g.
pine)
Hard –
wood
(e.g.
lauan)

Electronic function

The tool is equipped with the electronic functions for
easy operation.
• Active Feedback sensing Technology
If the tool is swung at the predetermined accelera-
tion during operation, the motor is forcibly stopped
to reduce the burden on the wrist.
NOTICE:
Hold the tool firmly while operating.
NOTICE:
If any malfunction occurred with the
electronic function, the light blinks for 3 seconds,
and then, turns off. In that case, contact with Makita
Authorized or Factory Service Centers to repair.
NOTE: This function does not work if the acceleration
does not reach the predetermined one when the tool
is swung.
NOTE: If the tool is forcibly stopped, release the
switch trigger, and then pull the switch trigger to
restart the tool.
23 24 25 26 27
–
–
2 3 4 5 6
M5 M6
ø4.1 x 38 –
ø3.5 ø4.1 x 38
x 22
28 29 30 31 32
–
ø9 x 75
ø9 x 75
7 8 9 10 11 12
ø5.1 x 50 –
– ø5.1 x 50
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
drill bit
Optional accessory
► 1. Sleeve 2. Close 3. Open
Turn the sleeve counterclockwise to open the chuck
jaws. Place the driver bit/drill bit in the chuck as far
as it will go. Turn the sleeve clockwise to tighten the
chuck. To remove the driver bit/drill bit, turn the sleeve
counterclockwise.
10 ENGLISH
33 34 35 36 37
– ø10 x 90
–
13 14 15 16 17
–
ø6.2 x 63
– ø6.2 x 63
Always be sure that the tool is
1
2
38 39 40 41
–
ø10 x 90 –
18 19 20 21
–
–
3