Advertisement
Quick Links
10260 Series Auto/Manual Switch kit
Replacement/Upgrade Instructions
Document Information
Number: 62-86-33-34
Effective: 5/04
Supersedes: None
Summary
This kit contains a new auto/manual switch assembly for your 10260 actuator.
Procedure
See Table 1 for procedure.
WARNING
WARNING
Disconnect power before accessing components inside the instrument.
ATTENTION
When working with circuit cards always protect against electrostatic discharge by wearing a grounded wrist
strap.
Step
1
Remove lower rear cover.
2
Remove terminal board plate.
3
If replacing the switch, disconnect switch wires and remove switch:
• Disconnect the auto/manual switch wires from terminals 9, 10, 11, and 12 (upper terminal board).
Disconnect the three auto/manual switch wires connected to the bottom terminal board, record the colors of
the wires removed and their associated terminal numbers.
• Remove switch knob by pulling it off the shaft.
• Remove nut securing switch to side of unit.
• Pull switch out of unit side wall.
62-86-33-34
51309623-501
Table 1 10260A Auto/Manual Switch Installation Procedure
Action
Page 1 of 2
Advertisement
Related Manuals for Honeywell 10260 Series
Summary of Contents for Honeywell 10260 Series
- Page 1 10260 Series Auto/Manual Switch kit Replacement/Upgrade Instructions 51309623-501 Document Information Number: 62-86-33-34 Effective: 5/04 Supersedes: None Summary This kit contains a new auto/manual switch assembly for your 10260 actuator. Procedure See Table 1 for procedure. WARNING WARNING Disconnect power before accessing components inside the instrument.
- Page 2 Step Action Install new switch: • See Figure 1. Attach switch label to side wall. • Remove nut from threads on switch. Insert switch through side wall. Make sure the stub engages the small hole. • Screw the nut onto the switch shaft and tighten it securely. •...