Makita DUN500W Instruction Manual page 14

9. Insert the protrusion on the shear blades to the
hole on the rod, then align the position of the felt pad
with the holes on the tool, and then attach the sleeves.
1
3
4
► 1 . Felt pad 2. Protrusion 3. Hole 4. Sleeve
NOTICE:
Apply a small amount of grease to the
inner periphery of the hole of the rod.
NOTICE:
Be careful not to lose the sleeves.
10. Align the holes on the sleeves and the shear
blades with the holes on the tool, and then tighten 2
bolts to fix the shear blades.
1
► 1 . Bolt 2. Hole
2
2
14 ENGLISH
11. Attach the bearing and the rod.
2
3
► 1 . Rod 2. Small hole 3. Bearing
NOTICE:
Apply a small amount of grease to the
inner periphery of the small hole of the rod.
NOTICE:
Make sure that the protrusion on the
shear blades fits in the small hole on the rod.
12. Attach plate B, plate A, and the gasket.
► 1 . Gasket 2. Plate A 3. Plate B
13. Align the hole in the plate with the protrusion on
the shear blades so that the protrusion fits in the hole.
► 1 . Protrusion 2. Plate
1
1
2
3
1
2