Using Your Blender - Breville Anthony Worall Thompson VBL030 Manual

using your blender

1. Remove the lid from the jug and add the ingredients. Alternatively remove the stopper from
the lid and pour or feed the ingredients through the hole in the lid.
2. Replace the lid and/or the stopper.
3. Plug your blender into a suitable supply socket and select the desired blender program by
pressing the button on the control panel.
Depending on the selected program your blender may operate at different speeds, or stop
and start during use. This is completely normal and is not indicative of a fault.
You can add more ingredients while your blender is running by removing the stopper and
inserting or pouring them through the hole in the blender lid.
Never try to remove the blender lid while your blender is operating.
Overloading the blender jug with more than 1. litres could cause the motor to stall. Should
the motor stall, turn your blender off, unplug it from the socket and remove a portion of the
mixture before continuing.
Never place your fingers or hands into your blending jug when it is in operation or
when your blender is plugged it.
. When you have made your recipe, switch your blender off, unplug it and remove the jug from
the base. Pour or remove the contents of the jug using a plastic or rubber spatula.
preset programs
• Press the button once to select the preset.
• The program will start. Wait until your blender does the rest (unless the recipe indicates
adding more ingredients during blending).
• Your blender will stop automatically. Alternatively press the Stop button to finish cycle.
manual programs
• + (fast) and – (slow): These buttons allow you to manually adjust the blending speed in 8
steps. Simply press the fast or slow button repeatedly while your blender is running to change
the speed.
• Pulse: The pulse button allows precise control of the duration and speed of blending. Press
and hold the pulse button to start processing, and release it to stop.
• Stop: Press at any time to stop blending wether in manual mode or using a preset program.
When using the + and – manual buttons to process food, don't allow your blender
to operate continuously for more than 1 minute without allowing it to rest for a
short time.
1