Cisco D9800 Installing Manual page 4

Rear Connector Panels
Connector
SDI 1 and SDI 2
CVBS (Composite Video
Output)
HDMI
ASI IN and ASI OUT
(D9800-SS)
ASI I/O 1 and ASI I/O 2
(D9800-MS)
Cue Tone/Cue Trigger
Relay Output
USB
Management
Cisco D9800 Network Transport Receiver Version 3.11 Installation and Configuration Guide
4
Description
The SDI outputs provide serial digital video with embedded
audio output for applications. The following lists the
supported SDI standards:
• HD-SDI (SMPTE-292M)
• SD-SDI (SMPTE ST 259)
• 3G-SDI (SMPTE ST 424)
This is only available on the single-stream units
Note
with the SDI option installed (D9800-3G-SDI).
The composite video output provides one SD composite
video output for monitoring applications and downstream
equipment.
This is available on the single-stream units
Note
only.
The HDMI output is for monitoring purposes only.
This is available on the single-stream units
Note
only.
Asynchronous Serial Interface (ASI) input and/or output
ports. The single-stream units have one ASI input port and
one ASI output port. The multi-stream units have two ASI
input and/or output ports.
Program relay provides programmed responses for alarms,
cue trigger states for ad-insertion equipment, or a cue tone
output for connection to ad-insertion equipment.
Note This is available on the single-stream units
only.
This is not supported in the current release.
Supports the following network protocols: SSH, HTTPS,
SNMP, Syslog, and NTP.
Installing the D9800 Network Transport Receiver
Type
BNC
BNC
HDMI Type A
receptacle (female)
BNC
15-pin sub-D
female
—
RJ-45