Cisco UCS E Series Hardware Installation Manual page 34

Online Insertion and Removal E-Series Servers
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Online Insertion and Removal E-Series Servers
Online insertion and removal (OIR) provides uninterrupted network operation, maintains routing information,
and ensures session preservation on the Cisco 3900 series ISR G2 and the Cisco ISR 4000 series. You can
use online insertion and removal to install or replace hardware without affecting system operations.
Note OIR is not supported on the EHWIC E-Series NCE.
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
34
Command or Action
Router# hw-module subslot slot/subslot
session imc
Server# scope cimc
Server/cimc# scope firmware
Server/cimc/firmware# update tftp-ip-address
path-and-filename
Server/cimc/firmware# show [detail]
Server/cimc/firmware# activate [1 | 2]
Click Ctrl a Ctrl q.
Router# hw-module
subslotslot/subslotmaintenance disable
Router# hw-modulesubslotslot/subslot reload
Purpose
Starts a CIMC session.
From the CIMC CLI, enters the CIMC
command mode.
Note Enter the commands in Step 3
through Step 8 from the E-Series
Server.
Enters the CIMC firmware command mode.
Starts the CIMC firmware update. The server
will obtain the update firmware at the specified
path and file-name from the TFTP server at
the specified IP address.
Displays the available firmware and status.
Make sure that the upgrade process
Caution
displays 100% before moving to
step 7.
Activates the selected image. If no image
number is specified, the server activates the
currently inactive image.
Exits the CIMC session.
Enables error recovery.
Enter the commands in Step 9 and
Note
Step 10 from the router.
Reloads the E-Series Server.
This reload power-cycles the
Note
E-Series Server.