Cisco UCS E Series Hardware Installation Manual page 25

LED
Power
GE Port
LEDs
6
7
8
Basic Workflow for Installing the E-Series Server or the SM E-Series NCE in the SM Slot
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Tools and Equipment Required for Installation
• Number-1 Phillips screwdriver or a small flat-blade screwdriver
• ESD-preventive wrist strap
• Tape to secure DC circuit breaker handle—Applicable for routers that use DC power
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
Basic Workflow for Installing the E-Series Server or the SM E-Series NCE in the SM Slot
Color State
Green • Steady—CIMC and the CPU are both operating normally.
• Blinking—The CPU is operating normally, and CIMC is booting up.
Amber • Steady—CIMC is operating normally, and the CPU is powered down.
• Blinking—CIMC is in the process of booting up, and the CPU is powered down.
Green Left LED shows the speed of the Ethernet cable:
• 1 Blink—10 Mb/s speed.
• 2 Blinks—100 Mb/s speed.
• 3 Blinks—1 Gb/s speed.
Green Right LED shows whether the link is established.
• Steady—Link is established.
• Off—No link is established.
This is memory installed on the DIMM 0 slot.
This is the DIMM 1 slot.
This is the DIMM 2 slot.
Command or Action
Reference Topic
Gather the required tools and equipment.
Remove the blank faceplates from the SM slots
that you want to use.
Depending on the type of server that you want
to install either remove or install the slot
divider.
Install the E-Series Server or SM E-Series NCE
into the router.
Verify the E-Series Server or SM E-Series NCE
installation.
Purpose
Action
Tools and Equipment Required for Installation,
on page 25
Removing the Blank Faceplate from the
Router's SM Slot, on page 26
Preparing the Router's SM Slot for E-Series
Server or SM E-Series NCE Installation, on
page 26
Installing the E-Series Server or the SM
E-Series NCE into the Router, on page 29
Verifying E-Series Server or SM E-Series NCE
Installation, on page 32
25