Makita Makstar BPB180 Technical Information page 7

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -5. tension Plate and Slide Plate
DISASSEMBLING
1) Remove the wheel on the front side.
2) From slide plate, remove the three tapping screws that fasten slide plate and the pan head screw that fixes lever 60.
(Fig. 16)
At this time, lever 60 is removed from front wheel cover. Be careful with fall of the lever.
Note: Be careful not to confuse the two kinds of screws when assembling.
3) Put tension plate section on Ring 22 (1R217), and disassemble by striking it with slotted screwdriver as illustrated in
Fig. 17.
Note: You may feel a small shock when the compressed springs 11 are released.
Fig. 16
Pan head screw for fixing lever 60
Tapping screws
ASSEMBLING
1) Set two compression springs 11 to tension plate, and then align the hole of slide plate with the hole of tension plate.
2) See Fig. 18. While pushing tension plate against slide plate, compress compression springs 11 by pulling tension plate
in the direction of the black arrow using water pump pliers till tension plate is set in place.
Fig. 18
Protrusions of Tension plate
Slide plate
Fig. 17
Insert two Tension plate ends
into two holes each in Slide
plate
Slide plate
1R217
Compression spring 11
Hook the protrusions of Tension plate
to the protrusions of Slide plate as
illustrated below.
Protrusions of Slide plate
P 7 / 10
Tension plate