Advertisement
Install the gearbox/
motor assembly into the
chassis, taking care to
keep the chute gasket
in place. Plug the motor
cable into the board if
not yet connected.
Then, secure the three
screws which mount the
assembly to the chassis.
Re-seat the safety
interlock switch onto its
posts. Ensure that the
button side faces inward,
and that the two posts
are flush with the top of
the switch.
www.baratza.com
Pg. 5
Route motor wires around front and chute gasket below
pulse button wires.
Route these wires
behind chassis screw
support@baratza.com
rev. 4/16/2019
Advertisement
