Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
●
The system can be used as an alarm clock,
whereby DISC, USB or TUNER is switched on at a
set time. The clock time needs to be set first
before the timer can be used.
1
In active mode, press and hold TIMER on the
remote control for more than three seconds.
➜
"ON TIME" flashes.
2
Press TIMER to enter the time setting mode.
➜
The hour digits flash on the display screen.
3
Turn VOLUME +/- on the front panel or press
VOL +/- on the remote to set the hours and
then press TIMER to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOLUME +/- on the front panel or press
VOL +/- on the remote to set the minutes and
then press TIMER to confirm.
➜
"ON TIME" flashes.
5
Turn VOLUME +/- on the front panel or press
VOL +/- on the remote to select "SOURCE".
6
Press TIMER to enter the source setting mode.
7
Press SOURCE on the front panel repeatedly
or press DISC, USB/MP3 LINK or TUNER on
the remote to select source and then press
TIMER to confirm.
34
●
Before setting timer, make sure the music source
has been prepared.
DISC – load the disc.
USB – connect a suitable USB device.
TUNER – tune to the desired radio station.
For TUNER mode:
a. Turn VOLUME +/- on the front panel or
press VOL +/- on the remote to select a preset
station and then press TIMER to confirm.
8
Turn VOLUME +/- on the front panel or press
VOL +/- on the remote to select "VOL XX".
9
Press TIMER to enter the volume setting mode.
0
Turn VOLUME +/- on the front panel or press
VOL +/- on the remote to set the volume level
and then press TIMER to confirm.
➜
The timer is now set.
●
In active mode, press TIMER ON/OFF on the
remote control to activate or deactivate the
timer.
➜
appears if activated, and disappears if
deactivated.
Notes:
– Only DISC, USB and TUNER can be selected as
the source for the timer.
– The system will exit the timer setting mode if no
button is pressed within 10 seconds.