Preparations; Step 1:Inserting Batteries Into The Remote Control; Using The Remote Control To Operate The; Step 2: Setting The Clock - Philips FWD18/98 User Manual

Preparations

IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1
Open the battery compartment.
2
Place two batteries (Type R03 or AAA, not
supplied) in the compar tment with the correct
polarity as indicated by "+" and "–" symbols.
3
Close the cover.

Using the remote control to operate the

system
1
Point the remote control
directly at the remote
sensor (iR) on the front
pane.
2
Then select the desired
function (for example í,
ë).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
16

Step 2: Setting the clock

1
Go to Standby mode.
2
Press and hold CLOCK on the front panel.
➜
The hour digits flash on the display screen.
3
Turn the VOLUME -/+ control on the front
panel or press VOL +/- on the remote to set
the hours.
4
Press CLOCK again.
➜
The minute digits flash on the display screen.
5
Turn the VOLUME -/+ control on the front
panel or press VOL +/- on the remote to set
the minutes.
6
Press CLOCK to confirm the clock setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.

Setting the TV set

IMPORTANT!
– Make sure you have completed all the
necessary connections.
1
Press SOURCE repeatedly on the set or press
DISC on the remote control to select disc mode.
2
Turn on the TV set and set to the correct Video-
In channel. You should see the blue Philips DVD
background screen on the TV set.
➜ You may go to channel 1 on your TV set, then
press the channel down button repeatedly until
you see the Video In channel.
➜ Or, you can use the TV remote control to
select different video modes.
➜ Or, set TV to channel 3 or 4 if you are using
an RF modulator.
Selecting the color system that
matches your TV set
This DVD system is compatible with both NTSC
and PAL. For the playback of a DVD disc on this
DVD system, the color systems of the DVD, TV
set and DVD system should match.