Commissioning; General Notes; Visual Inspection; Selection Gas Type With Unit - Honeywell MSR PolyGard 2 MGC2-K User Manual

User Manual - PolyGard
Multi-Gas-Controller MGC2-K Honeywell

9 Commissioning

9.1 General Notes

Only trained technicians should perform the following when commissioning:
•
Check for correct mounting location.
•
Check if connection is correct according to connection diagram.
•
Check power voltage.
For fast and comfortable commissioning, we recommend proceeding as follows. For digital devices with self-
monitoring all internal errors are visible via the LED. All other error sources often have their origins in the field,
because it is here where most of the causes for problems in the field bus communication appear.

9.2 Visual Inspection

•
Right cable type used.
•
Correct mounting height according to definition in Mounting.
•
Led status

9.3 Selection Gas Type with Unit

The selection of the desired and connected gas sensor type is made by pre-set values.
If other gas sensor types are connected, you have to adjust them with the display, because otherwise the
device will show wrong measuring values.
®
PolyGard is a registered trademark of MSR
Phone 0049(0)8531/9004-0 Fax: 0049(0)8531/9004-54
MSR-Electronic GmbH, Bgm.-Schoenbauer-Str. 13, D 94060 Pocking www:msr-electronic.de Made in Germany
®
2
Page
35
GAMGC2-K_E_0320
Specification subject to change without notice