Cisco ONS 15600 Installation Instructions Manual page 8

NTP- E104 Install Cable Routing Modules and Kick Plates
If you want to install CRMs, continue with the
Step 5
Plates" procedure on page
Power and Ground" procedure on page
Stop. You have completed this procedure.
NTP-E104 Install Cable Routing Modules and Kick Plates
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
To accommodate the CRMs, the bay must have 150 millimeters (6 inches) of open space on either side
Note
(900-mm [35.4-inch] footprint).
Two people are required to perform this procedure.
Note
If you want to install narrow CRMs, complete the
Step 1
page
If you need to remove narrow CRMs (vertical fiber routers) so you can install wide CRMs, complete the
Step 2
"DLP-E120 Remove the Narrow CRMs" task on page
Cisco ONS 15600 Procedure Guide, R7.0
1-8
1-8. If CRMs are already installed, continue with the
This procedure explains how to install narrow CRMs or, if necessary,
remove any previously installed narrow CRMs and install the wide CRMs.
Screwdriver
Retaining screws
900-mm kick plates (53-2178-01)
Wide cable routing module (CRM) kit (53-2181-XX) (optional):
•
•
•
•
•
Narrow CRM kit (53-2193-01) (optional):
•
•
•
•
As needed
Onsite
None
17-33.
Chapter 1
"NTP-E104 Install Cable Routing Modules and Kick
1-9.
Latch catches (2 left and 2 right)
Velcro tie-wrap (26)
Wide CRMs (2 left and 2 right)
6-32 panhead screws (8; for latch catches)
8-32 panhead screws (10; for wide CRMs)
Fiber radiuses (2; left and right)
Narrow CRMs (2; left and right)
6-32 panhead screws (4; for fiber radiuses)
8-32 panhead screws (6; for narrow CRMs)
"DLP-E142 Install the Narrow CRMs" task on
17-18.
Install the Bay and Backplane Connections
"NTP-E4 Install the Bay
78-17203-01