Device Configuration Jumpers - Honeywell Temaline TS2 Installation Manual

Device Configuration Jumpers

There are seven configuration jumpers (CN1) on TS2 Lonwork
Xboard as shown in the following picture.
5.
24
https://extranet.honeywell.com
CR34 Ethernet 10 / 100 - Orange
ON = Ethernet working at 100 Mbit/s
OFF = Ethernet working at 10 Mbit/s
RJ45 green Ethernet physical Link
LED
ON = Good link
OFF = no link
RJ45 yellow TX / RX activity
LED
Blinking when RX or TX is active
OFF = no RX/TX activity
Figure 16 – Configuration jumpers
For normal operation, configure the jumpers as specified in Table
Jumper Function
CN1.1 Spare position
CN1.2 Presence of the battery. It instructs the device on the
presence of the internal battery. The use of the internal
battery can be avoided when the device is powered with
an external UPS.
When the jumper is Closed and the device is restarted,
the absence of the internal battery is no more considered
a failure for the device.
Open = battery present
Close = battery not present
CN1.3 FW application roll back. When the jumper is closed and
the device is restarted, it restores the alternative version
of the application present on the device (if any).
Table 4 - CPU switches and LEDs
-
-
blink
Default state
Close
Open
(Battery present)
Open