Honeywell Temaline TS2 Installation Manual page 5

Warnings and Cautions
Before installation
Before installation, TURN OFF the external circuit breaker which supplies
Warning:
power to the device.
Before connecting the device to the power supply, verify that the output voltage is
within specifications of the power supply. (See "Technical specifications" on page
37.)
Do not apply power to the device until after the installation has been completed.
The equipment can be damaged if this precaution is not observed.
Fire Safety and Liability Notice
Never connect card readers to any critical entry, exit door, barrier, elevator or
Warning:
gate without providing an alternative exit in accordance with all the fire and life
safety codes pertinent to the installation.
These fire and safety codes vary from city to city and you must get approval from
local fire officials whenever using an electronic product to control a door or other
barrier. Use of egress buttons, for example, may be illegal in some cities. In most
applications, single action exit without prior knowledge of what to do is a life safety
requirement. Always make certain that any required approvals are obtained in writing.
DO NOT ACCEPT VERBAL APPROVALS SINCE THEY ARE NOT VALID.
Damage during shipment
IF ANY DAMAGE TO THE SHIPMENT IS NOTICED, A CLAIM MUST
Caution:
BE FILED WITH THE COMMERCIAL CARRIER RESPONSIBLE FOR THE
DAMAGE.
Electrostatic discharge
Electrostatic discharge (ESD) can damage integrated circuits and modules. To
Caution:
prevent damage always follow these procedures:
Use static shield packaging and containers to transport all electronic components,
including completed reader assemblies.
Handle all ESD sensitive components at an approved static controlled workstation.
These workstations consist of a desk mat, floor mat and an ESD wrist strap.
Workstations are available from various vendors.
Note: This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the installation and user guides, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Disclaimer – Product Liability; Mutual Indemnification
If a Customer receives a claim that a Product or any component thereof has caused
personal injury or damage to the property of others, Customer shall immediately
notify Honeywell S.r.l. Italy in writing of all such claims. Honeywell S.r.l. Italy shall
1