Advertisement
65. Position template B on the center console as shown,
and attach it to the center console with masking
tape.
MASKING
TAPE
CENTER CONSOLE
66. Using a pushpin, mark the center console at the
marks on template B. Remove template B.
67. While wearing eye protection, drill an 8 mm hole at
each marked point. Start with a 3 mm drill bit and
finish with an 8 mm drill bit only at the two rear
marks. Use the drill bits with masking tape attached.
3 mm
DRILL BIT
DRILL
3 mm
8 mm
DRILL BIT
REAR
MARK
CENTER CONSOLE
68. Using a 28 mm hole saw, enlarge the front hole.
Remove any burrs.
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
PUSHPIN
3 MARKS
TEMPLATE B
820505A
DRILL
28 mm
HOLE SAW
REAR
MARK
FRONT
MARK
820506A
AII 50347 (1308)
69. Install the center console. Route the i-VES harness,
DIN cable "A" and DIN cable "B" through the 28 mm
hole in the center console.
i-VES
HARNESS
DIN CABLE "B"
CENTER CONSOLE
70. Re-plug the vehicle connectors, and reinstall the
vehicle connectors to the vehicle clip.
CENTER
CONSOLE
VEHICLE CONSOLE
LIGHT HARNESS
VEHICLE
VEHICLE
CLIP
CONNECTORS
71. Route the vehicle console light harness through the
console light opening, and reinstall the center
console rear cover.
DIN
CABLE "A"
28 mm HOLE
820507A
CONSOLE LIGHT
OPENING
VEHICLE
CONNECTORS
CENTER CONSOLE
REAR COVER
820508A
17 of 28
Advertisement
