Advertisement
59. Secure the i-VES harness and the DIN cables to the
vehicle harness with one wire tie.
DIN CABLE "B"
WIRE TIE
i-VES
HARNESS
60. Slide the center console cup holder forward, and
slide the inner cover forward. Open the console
cover.
INNER COVER
Slide.
CUP HOLDER
Slide.
16 of 28
DIN CABLE "A"
DASHBOARD
CENTER LOWER
COVER OPENING
VEHICLE
HARNESS
820501A
CONSOLE
COVER
Open.
CENTER CONSOLE
820502A
61. Position template A on the center console as shown,
and attach it to the center console with masking
tape.
TEMPLATE A
CENTER CONSOLE
62. Using a pushpin, mark the center console at the
marks on template A. Remove template A.
63. To prevent drilling through the inner panel, wrap
masking tape around the drill bit at the measurement
shown.
15-20 mm
64. While wearing eye protection, drill an 8 mm hole at
each marked point. Start with a 3 mm drill bit and
finish with an 8 mm drill bit. Remove any burrs.
AII 50347 (1308))
CENTER CONSOLE
MASKING
TAPE
CENTER CONSOLE
2 MARKS
DRILL
BIT
MASKING TAPE
Wrap masking tape
around the drill bit.
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
PUSHPIN
820503A
3 mm
8 mm
DRILL BIT
DRILL
820504B
Advertisement
