Table of Contents
Advertisement
Chapter 4
Configuring the OC12 POS Line Card
Compiled Thu 29-Nov-01 04:27 by
Image text-base:0x40008970, data-base:0x417EE000
ROM:System Bootstrap, Version 12.1(20010827:230108) [hih-rommon_1_0
104],
Currently running ROMMON from ROM 0
BOOTLDR:7300 Software (C7300-BOOT-M), Version 12.1(1.23.61), CISCO
DEVELOPMENT TEST VERSION
Router uptime is 3 minutes
System returned to ROM by power-on
System image file is
"tftp://223.255.254.254/muck/nlaw/c7300-js-mz.121-99."
cisco 7300 (NSE100) processor (revision B) with 114688K/16384K bytes of
memory.
Processor board ID CHASSIS##16
R7000 CPU at 350Mhz, Implementation 39, Rev 3.2, 256KB L2, 1024KB L3 Cache
4 slot midplane, Version 65.48
Last reset from watchdog nmi
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
PXF processor tmc0 running 'system:pxf/ucode1' v1.4 is active
PXF processor tmc1 running 'system:pxf/ucode1' v1.4 is active
1 FastEthernet/IEEE 802.3 interface(s)
2 Gigabit Ethernet/IEEE 802.3 interface(s)
1 Packet over SONET network interface(s)
509K bytes of non-volatile configuration memory.
31360K bytes of ATA compact flash in bootdisk (Sector size 512 bytes).
31360K bytes of ATA compact flash in disk0 (Sector size 512 bytes).
Configuration register is 0x0
Using the show diag Command
Display the types of line cards installed in your system (and specific information about each) using the
show diag slot command, where slot is the slot in a Cisco 7304 router.
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
Cisco 7304 Router
Following is an example of the show diag slot command for an OC12 POS line card in slot 3 of a Cisco
7304 router:
Router# show diag 3
Slot 3/0:
OL-3437-01
POS OC12 Single Mode Short Reach Line Card, 1 port
Line Card state:Active
Insertion time:00:00:29 ago
Bandwidth points:1244000
EEPROM contents at hardware discovery:
Hardware Revision
:1.0
OC12 Packet Over SONET Line Card Installation and Configuration
Checking the Configuration
4-9
Advertisement
Table of Contents
