Table of Contents
Advertisement
Chapter 2
Preparing for Installation
Preventing Electrostatic Discharge Damage
Electrostatic discharge (ESD) damage, which can occur when electronic cards or components are
improperly handled, results in complete or intermittent failures. Line cards and processor modules
consist of printed circuit boards that are fixed in metal carriers. Electromagnetic interference (EMI)
shielding and connectors are integral components of the carrier. Although the metal carrier helps to
protect the board from ESD, use a preventive antistatic strap during handling.
Following are guidelines for preventing ESD damage:
•
•
•
•
•
•
•
•
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
Caution
between 1 and 10 megohms (Mohms).
Laser Safety
The single-mode aperture port contains a Class 1 laser warning label, as shown in
Figure 2-1
CLASS 1 LASER PRODUCT
Because invisible laser radiation may be emitted from the aperture of the port when no fiber cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures.
Warning
Class 1 laser product.
OL-3437-01
Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
Connect the equipment end of the strap to an unfinished chassis surface.
When installing a component, use line card levers and locking thumbscrews to properly seat the bus
connectors in the backplane. These devices prevent accidental removal, provide proper grounding
for the system, and help to ensure that bus connectors are properly seated.
When removing a component, use line card levers and locking thumbscrews to release the bus
connectors from the backplane.
Handle carriers by available handles or edges only; avoid touching the printed circuit boards or
connectors.
Place a removed component board-side-up on an antistatic surface or in a static shielding container.
If you plan to return the component to the factory, immediately place it in a static shielding
container.
Avoid contact between the printed circuit boards and clothing. The wrist strap only protects
components from ESD voltages on the body; ESD voltages on clothing can still cause damage.
Never attempt to remove the printed circuit board from the metal carrier.
Class 1 Laser Warning Label on OC12 POS Line Card
LASERPRODUKT DER KLASSE 1
PRODUIT LASER DE CLASSE 1
PRODUCTO LASER CLASE 1
OC12 Packet Over SONET Line Card Installation and Configuration
Safety Guidelines
Figure
2-1.
2-5
Advertisement
Table of Contents
