Honeywell X-Superteam XPS-100 System Operation Manual page 15

c
Bad SectorSI
ayl=XXX,trk=8,sec=1
6.
Do
you want to insert a bad sectors list!
(y res], or moD
7.
cyl1ndenO/
tracks
0/
b.c.a.i.:O/
To create or update the map of
bad sectors, answer y and press.
RETURN. If the map is to be
created, the values to enter can
be found on the bad sector
label
on the disk.
Input the corresponding value
and press RETURN.
.. Input the· corresponding value
and . press· RETURN.
Input the corresponding value
and press RETURN.
Continue until the bad sectors
are completed, then enter q.
Do you want to verify/correct the bad sector ·Llst! (y[esl, or nCo])
To check the bad sectors list,
enter y. . Otherwise, answer n
and
skip
to· point 8.
Press RETURN
The list reappears with the
cylinder, track and b.c.a.i.
values specified, followed by the
same question.
NOTE: . . The' b.c.a.i. displayed
is
not the same as the one entered. In
·.fact, the b.c.a.i. entered
is
the bad byte, while the one which
is
displayed
is
actually the first byte of the bad sector. The
value input must be betwen the' value displayed and the value
displayed increased by 573.
Do you want to verify/correct the bad sector List! (y[es], or n roD
Answer n and press RETURN.
11