Port And Slot Configuration Worksheet - Cisco 7513 Series Manual

Port and Slot Configuration Worksheet
Port and Slot Configuration Worksheet
The port and slot configuration worksheet (Table 1) is used in conjunction with Figure 12 to assist
in planning and documenting your use of the slots in a Cisco 7513 or Cisco 7576 router. Figure 12
shows the dual CyBus backplane without the Time Division Multiplexing (TDM) connectors found
on the Cisco 7576.
Cisco 7513 Slot Assignments
The dual CyBus backplane has 13 slots: interface processors are placed in slots 0 through 5 and slots
8 through 12. RSPs are placed in slots 6 and 7.
Cisco 7576 Slot Assignments
The Cisco 7576 consists of two independent routers on a single split backplane. These are designated
router A and router B.
•
•
Figure 12
28 Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions
Router A
— Interface processors are placed in slots 0 through 5
— An RSP is placed in slot 6
Router B
— Interface processors are placed in slots 8 through 12
— An RSP is placed in slot 7
Slot Numbering (Use with Table 1)