Tools And Parts Required - Cisco 7513 Series Manual

Figure 4
19 in. required
for blower removal

Tools and Parts Required

This section lists the tools and parts you will need to complete these replacement procedures. Have
the necessary tools on hand so that you can complete the replacement without interruption:
•
To replace the chassis cover, you need a 3/16-inch, flat-blade screwdriver to loosen the captive
screws on the chassis cover panel
•
To install a replacement chassis, you need a number 1 phillips and a 3/16-inch, flat-blade
screwdriver for the captive installation screws on the processor modules (most of the carriers use
slotted screws, but some use phillips screws)
•
To install a new cable-management bracket or to move the bracket from the existing chassis, you
need the following tools and parts (pan head screws are included with the brackets):
— Number 1 phillips screwdriver
— Cable-management bracket
— Two M3 x 8-mm, phillips pan head screws
Chassis Footprint and Clearance Requirements for Maintenance
1.75 in. 4 places
18.93
in.
Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions
3.94 in.
12.73 in.
18.75
in.
21.23
in.
Tools and Parts Required
1.47
Plastic front
in.
panel end
14.57
in.
17.50
in.
11