Cisco 7513 Series Manual page 15

Figure 6
This completes the chassis removal procedure.
If you have not yet installed the new chassis in the rack, proceed to the next section.
Installing the New Chassis in the Rack
Mount the chassis in the rack before connecting any interface or power cables. If possible, install the
new, empty chassis in the rack first, and then install the system components from the old chassis. To
mount the chassis, install the ears on the chassis first, place the chassis in the rack, and then secure
the ears to the rack rails.
We recommend that two people perform this procedure. Before lifting the chassis, ensure that your
path to the rack is unobstructed.
To install the chassis in the rack, follow these steps:
Step 1
Step 2
Step 3
Lifting the Chassis
POWER
A
Two people are required to perform this step. With a person positioned at either side of
the chassis, grasp the bottom edge of the chassis with one hand near the front and the
handle on the side of the chassis with the other, as shown in Figure 6.
Grasping the chassis as shown in Figure 6, slowly lift the chassis in unison. To prevent
injury, avoid sudden twists or moves.
With the chassis positioned so the front is closest to the rack, insert the front of the chassis
into the rack between the brackets, and then slowly lower the chassis until it rests on the
two bracket ledges. (See Figure 7.)
Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions
Replacing a Rack-Mounted Chassis
POWER
B
15