Cisco 7513 Series Manual page 25

When the system starts up and operates successfully, the replacement procedure is complete, and
you can resume normal operation.
If the system still fails to start up or operate properly, or if you isolate the cause of the problem to a
failed component, contact a service representative for further assistance.
Note
parts. If the old chassis is still mounted in a rack, follow the steps in the "Removing the Existing
Chassis from the Rack" section on page 13" to remove it. Place spare interface processors or
interface processor fillers in the chassis slots, and move the chassis to the appropriate location for
storage or shipment.
Verifying the Installation Using show Command Descriptions and Examples
This section describes the various show commands that you can use to display system status and
configuration. If you installed the interface processors in the same slot locations that they occupied
in the old chassis, the interfaces should retain the same configuration. If you installed the interface
processors in different slot locations, the system will recognize the interfaces, but you will have to
use the configure command to reconfigure and enable them.
You can check the version of the default ROM image either by removing the board and checking the
ROM labels or by configuring the interface or system software to boot from ROM, restarting the
system, and using these same commands to check the running version.
Note
software that is being used.
Verifying the Installation Using show Command Descriptions and Examples
After you verify a successful installation, gather the old chassis and any remaining spares and
The following examples may differ based on the router model and version of Cisco IOS
Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions 25