Cisco Catalyst 6500 Series Installation Note page 16

Installing the CSM
Figure 6
Press left
Press left
Exerting too much pressure on the ejector levers will bend and damage them.
Caution
While pressing on the ejector levers, simultaneously close them to fully seat the supervisor engine
d.
or module in the backplane connector. The ejector levers are fully closed when they are flush with
the module faceplate. (See
Catalyst 6500 Series Switch Content Switching Module Installation Note
16
Clearing the EMI Gasket in a Vertical Slot Chassis
FAN
STATUS
o
o
INPUT FAN
OUTPUT
OK OK
FAIL
INPUT FAN
OUTPUT
OK OK
FAIL
Figure
Gap between the module
EMI gasket and the
module above it
1 mm
7.)
78-15751-01