Cisco SCE8000 Removal And Replacement Procedures page 33

Chapter 9 Removal and Replacement Procedures
Removing a SPA from a SIP
To remove a SPA from a SIP, see
At the SCE# prompt, enter reload shutdown and press Enter to power down the Cisco SCE 8000
Step 1
platform before installing or removing any module.
If attached, remove any cables from the SPA.
Step 2
To remove the SPA from the SIP, unfasten the captive installation screws on the SPA.
Step 3
Grasp the handles of the SPA and pull the SPA from the SIP.
Step 4
OL-26784-02
Figure 9-17 and do the following:
Cisco SCE8000 10GBE Installation and Configuration Guide
Removing a SPA from a SIP
9-33