Cisco SCE8000 Removal And Replacement Procedures page 17

Chapter 9 Removal and Replacement Procedures
If the captive installation screws are loose, the EMI gaskets on the installed modules will push adjacent
Note
modules toward the open slot, reducing the opening size and making it difficult to install the replacement
module.
Remove the module filler plate by removing the two Phillips pan-head screws from the filler plate. To
Step 5
remove a module, follow the procedure in the
Fully open both ejector levers on the new module. (See
Step 6
Figure 9-10
SCE8000-SCM-E
OPTICAL
BYPASS1
OL-26784-02
Ejector Levers and Captive Installation Screws
OPTICAL BYPASS
CONSOLE PORT1
10/100/ LINK/
1000 ACTIVE
"Removing a Module" section on page
Figure
STATUS
OPTICAL
AUX PORT2
BYPASS2
10/100/ LINK/
1000 ACTIVE
Ejector lever
Cisco SCE8000 10GBE Installation and Configuration Guide
Installing a Module
9-20.
9-10.)
SCE8000 EXTENDED SERVICE CONTROL MODULE
MASTER
SYSTEM POWER
M AS TE R
SY ST EM PO W
ER
Captive
installation
screws
9-17