Makita BV4500-118 Instruction Manual page 6

Fig.3
1. Switch trigger
the switch trigger to stop.
Control panel
position of the nose piece, or lock the buttons on the
control panel.
1 2
Fig.4
1. Button A 2. Button B 3. Button C 4. Control panel
Pulling force adjustment
To change the pulling force, follow the steps below.
1. Press button A for a few seconds.
2. Enter the value for the pulling force.
To change the value, press button C. To change the
digit, press button B. To set the value, press button A
for a few seconds. The value can be set between "0"
and "999".
NOTICE:
To break off a mandrel, set the value to
"900" or higher. When operating the tool without
breaking off a mandrel, set the value appropriate
for the operation.
Adjustment for initial position of
nose piece
1. Pull the switch trigger until the motor stops.
2. Press button A for a few seconds while pulling the
switch trigger.
3. Enter the value for the initial position while pulling
1
3
4
the switch trigger.
To change the value, press button C. To change the
digit, press button B. To set the value, press button A
for a few seconds. The value can be set between "-99"
and "0".
NOTE: The larger the value becomes, the tighter the
nose piece becomes. The smaller the value becomes,
the looser the nose piece becomes. (The value "0" is
the tightest and the value "-99" is the loosest.)
4. Release the switch trigger.
Locking the buttons
To lock the buttons on the control panel, press button A
and button C for a few seconds. To unlock the buttons,
press button A and button C for a few seconds again.
NOTE:
Lighting up the front lamp
Fig.5
1. Lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
releasing the switch trigger.
NOTICE:
When the remaining amount of the
battery becomes low, the lamp blinks a few times.
In this case, charge the battery or replace the
battery with a charged one.
NOTE:
the lamp. Be careful not to scratch the lens of lamp, or
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
6 ENGLISH
1