Wireless Communications - Maytag Amana PTC A Series Service Instructions Manual

PROPER INSTALLATION
2. To select a configuration feature code other than C1,
press the HEAT
comes up. To scroll to a previously viewed configuration
codes press the COOL
Once you have scrolled to the correct feature, then to se-
lect the option code for your desired configuration, press
either the up or down key
tions of the selected feature code.
To exit configuration mode:
Press the OFF
key. Configuration feature mode will
also exit if no keys are pressed for a period of two (2) min-
utes.
For the most common configuration settings SEE PAGE 31.
Additional codes are present and may be accessed within this
menu. Contact the manufacturer for additional information.

Wireless Communications

PTAC models PT****B***M, N or P have the option to use a
wireless thermostat and door sensor. These features will only
work on the models listed above. The thermostat and /or door
sensor will require an antenna for communication with the digi-
tal control board.
ANTENNA INSTALLATION FOR DT01A KIT
PTC***B00*P is the only hydronic model compatible with the
wireless thermostat
PREPARATION
1. Disconnect power to the unit by unplugging the power
cord at the wall outlet or subbase, or disconnect power
at the fuse box or circuit breaker.
2. If the cabinet front is screwed to the chassis, remove the
1/4" screw (or screws) located behind the inlet grille. Pull
the inlet grille forward from the top of the grille to access
screw(s).
26
key until the desired configuration
key.
to scroll through the op-
FRONT MOUNTING
HOLE
3. Remove cabinet front from chassis by tilting the bottom
of the front forward, lifting slightly up and forward.
4. Mount antenna housing with two screws as shown in fig-
ure above.
5. Plug wire harness from antenna into connector on the con-
trol board to the right of the master switch.
6. Re-apply power and check for led blink on antenna.
THERMOSTAT INSTALLATION FOR DS01A KIT
NOTE: A DT01* must be installed in the PTAC unit for the
DS01* to be operable.
Skip these steps if not installing.
1. Select thermostat mounting location about five feet above
the floor, on an inside wall, out of direct sunlight, away
from sources of radiant heat (lamps, fireplaces, heating
and air conditioning equipment, etc.), away from windows
or door to the outside, and avoid areas with poor air circu-
lation. Ensure location is out of the path of foot traffic where
a person might accidentally bump into the thermostats
and damage the device.
2. Remove thermostat from mounting plate by pulling apart.
3. Place thermostat mounting plate against the wall at de-
sired location and mark placement of mounting holes.
4. If mounting in drywall, tap plastic anchors into wall. For
other surfaces, drill a 3/16" hole.
5. Screw mounting plate to the wall. DO NOT SNAP THER-
MOSTAT INTO PLACE UNTIL AFTER BINDING PROCESS.
See Binding Instructions on page 28.
6. Install two (2) AAA batteries (included) into the back of the
thermostat. Terminals are marked "+" and "-" for polarity.
INDICATOR LIGHT LOCATED
TOWARD THE TOP OF ANTENNA