Advertisement
Available languages
Available languages
1
TCPA1BS
TCPA1BS
Installation instructions
Installation instructions
3a
General Information
General Information
The TCPA1BS is a wireless keyfob that may be worn around the neck, on a wrist band or as an apparel clip
The TCPA1BS is a wireless keyfob that may be worn around the neck, on a wrist band or as an apparel clip that
that may also be mounted to a desk. Pressing the keyfob button for at least 1 second and releasing it, sends a
may also be mounted to a desk. Pressing the keyfob button for at least 1 second and releasing it, sends a signal
signal to the panel.
to the panel.
Registration and Configuration
Registration and Configuration
1.
1.
4
*https://international.mytotalconnectcomfort.com
*https://international.mytotalconnectcomfort.com
2.
To start registration, press the keyfob button for 5 seconds.
2. To start registration, press the keyfob button for 5 seconds.
Battery Replacement (see figure on first page)
Battery Replacement (see figure on first page)
The TCPA1BS is powered by a long-life Lithium battery that may be replaced when a low battery is eventually
The TCPA1BS is powered by a long-life Lithium battery that may be replaced when a low battery is eventually
indicated by the control unit.
indicated by the control unit.
1.
Remove 4 screws and lift off cover.
1.
Remove 4 screws and lift off cover.
CR123 LITHIUM 3V
2.
Using a small flat-blade screwdriver remove old battery.
2. Using a small flat-blade screwdriver remove old battery.
3.
Insert new battery by placing new battery under the gold tab and then pressing down.
3. Insert new battery by placing new battery under the gold tab and then pressing down.
Ensure the positive (+) side of battery is face up after installation.
Ensure the positive (+) side of battery is face up after installation.
4.
Align cover and attach with 4 screws.
4.
Align cover and attach with 4 screws.
NOTE: When replacing the battery, wait a minimum of 10 seconds prior to installing the new battery.
NOTE: When replacing the battery, wait a minimum of 10 seconds prior to installing the new battery.
NOTE: Although water-resistant, please do not immerse in water at a depth below 10cm for more than 1 hour.
NOTE: Although water-resistant, please do not immerse in water at a depth below 10cm for more than 1 hour.
Specifications:
Unit Dimensions:
Specifications:
LED:
Unit Dimensions:
Battery:
LED:
Operating Temperature:
Battery:
Operating Temperature:
CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
CAUTION:
DISPOSE OF USED BATTERIES ACCORDING TO BATTERY MANUFACTURER
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
INSTRUCTIONS AND APPLICABLE REGULATIONS.
DISPOSE OF USED BATTERIES ACCORDING TO BATTERY MANUFACTURER
INSTRUCTIONS AND APPLICABLE REGULATIONS.
2a
2
1
www.
https://
WEB*
WEB
WEB*
1
2
39 mm diameter
lights when unit transmits
39 mm diameter
3-Volt CR2032 Lithium
lights when unit transmits
-10°C to +55°
3-Volt CR2032 Lithium
-10°C to +55°
1
3b
5
1
2
English
English
x2
2
2.5min
Advertisement
