Appendix D - Ietf Radius Attributes Support - D-Link DGS-1250 Series Reference Manual

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide

Appendix D - IETF RADIUS Attributes Support

Remote Authentication Dial-In User Service (RADIUS) attributes carry specific authentication, authorization,
information, and configuration details for the request and reply. This appendix lists the RADIUS attributes currently
supported by the Switch.
RADIUS attributes are supported by the IETF standard and Vendor-Specific Attribute (VSA). VSA allows the vendor to
create an additionally owned RADIUS attribute. For more information about D-Link VSA, refer to Appendix C -
RADIUS Attributes Assignment on page 302.
IETF standard RADIUS attributes are defined in the RFC 2865 Remote Authentication Dial-In User Service (RADIUS),
RFC 2866 RADIUS Accounting, and RFC 2868 RADIUS Attributes for Tunnel Protocol Support, and RFC 2869
RADIUS Extensions.
The following table lists the IETF RADIUS Authentication Attributes supported by the D-Link Switch.
Number
1
2
3
4
5
6
7
8
12
18
24
26
27
29
30
31
32
60
61
64
65
77
79
80
81
85
87
95
IETF Attribute
User-Name
User-Password
CHAP-Password
NAS-IP-Address
NAS-Port
Service-Type
Framed-Protocol
Framed-IP-Address
Framed-MTU
Reply-Message
State
Vendor-Specific
Session-Timeout
Termination-Action
Called-Station-ID
Calling-Station-ID
NAS-Identifier
CHAP-Challenge
NAS-Port-Type
Tunnel-Type
Tunnel-Medium-Type
Connect-Info
EAP-Message
Message-Authenticator
Tunnel-Private-Group-ID
Acct-Interim-Interval
NAS-Port-ID
NAS-IPv6-Address
303