NEC Univerge SV9100 System Hardware Manual page 268

4-18
MF Signal Sender (Sends caller information to CO for E911)

Call Progress Tone Detection

C-Channel Control

Conference Circuits: 64 Channel (when built-in modem is enabled) or

Caller ID Receiver: 80 Channels

A load switch which is used for initial system startup, resetting the

system, or when upgrading system software
One Serial Port (NEC production use only)

One SD/SDHC Card (VM) connector

One USB Port – USB 1.1/USB 2.0

Memory size – minimum of 32MB (normally 512MB or 1GB) should

be used.
USB device power consumption is less than 200mA (1W).

One Gbit Ethernet Port for VoIP function

Background Music/EXSP Control Port

Status LED

Two Audio Input/Output Terminals

One Music On Hold External Source

High-Level Data Link Control (HDLC) Packet Processing

Real Time Clock (tolerance 30 seconds/month)

Call Control Server (ex: Conference Bridge Server, Voice Mail Server,

SIP Server, RTP Forwarding, VoCoder Conversion)
One lithium battery (CR2032) which provides battery back-up of

system data and RAM memory for approximately 30 months.
The GCD-CP10 functions provided are:
Call Control Server

Conference Bridge Server

Voice Mail Server (voice mail requires proper licensing)

SIP Server

RTP Forwarding

VoCoder Conversion

96 Channel (when built-in modem is disabled)
Installing the SV9100 Blades
Issue 3.0