Advertisement
R
epair
[4] DISASSEMBLY/ ASSEMBLY
[4]-6. Clutch
DISASSEMBLING
Note: • Clutch can be easily removed with Impact driver without holding the piston.
• Do not remove Spark plug as compressed air resistance has to be used for the disassembling.
• Plug cap with Plug cap spring has to be removed from Spark plug.
(1) Remove the clutch section by unscrewing two M8 shoulder hex bolts.
Then, remove M6x14 Hex head bolt with Impact driver. (Fig. 17)
(2) Install 1R364 on Holder then screw two bolts into Holder as drawn in Fig. 18
instead of M8 Shoulder hex bolts. Holder is removed from Engine.
Fig. 17
M6x14 Hex head bolt
ASSEMBLING
(1) After putting the clutch section (two Clutch shoes and two Springs), two Wave washers 10 and two Flat washers 8
on Holder, tighten them with two M8 shoulder hex bolts. (Fig. 19)
Note: Face the marking of "
(2) Put the assembled part, Flat washer 6, Spring washer 6 and M6x14 Hex head bolt on the crank shaft of Engine,
then tighten the bolt to 12 N·m with 1R219, 1R220 while inserting 1R155 into Spark plug hole to lock Piston
to prevent the rotation of the crank shaft. (Fig. 20)
Fig. 19
M8 Shoulder hex bolt
Wave washers 10
Clutch section
Flat washers 8
Holder
M8 Shoulder hex bolt (2pcs.)
Clutch section
" to the outside as drawn in Fig. 19A.
Fig. 19A
marking of "
Fig. 18
1R364
M8 bolts
(the components of 1R364)
Fig. 20
M6x14 Hex head bolt
"
P 6/ 17
Holder
Spring washer 6
Flat washer 6
Advertisement
