Assembling - Makita DJR187 Technical Information

5-3-2

Assembling

[1] Assemble by reversing the disassembly procedure. Be careful to check the points mentioned in Fig. 5-3-2-1-1, Fig. 5-3-2-1-2.
Note: When assembling Rotor ass'y to Motor housing, be careful not to pinch your fingers between Rotor ass'y and Baffle plate.
Fig. 5-3-2-1-1
Caution for Handling of Rotor ass'y (Armature ass'y)
When handling or storing multiple Rotors, be sure to keep a proper distance between Rotors as shown in Fig. 5-3-2-1-1.
Because Rotor has strong magnetic force, failure to follow this instruction could result in:
Finger injury caused by pinching between Rotors pulling each other
·
Magnetic loss of Rotors or damage on the magnet portion of Rotor (Fig. 5-3-2-1-2)
·
5-3-2-1 For DJR187, DJR360
Fig. 5-3-2-1-3
[2] Set the U-shaped legs of Bearing retainer 66 into the
groove of Gear housing L assembly to assemble
Armature ass'y.
Note: If it is hard to assemble Armature ass'y, warm Gear
housing L assembly with a heat gun.
U-shaped legs of
Bearing retainer 66
Groove of Gear
housing L assembly
15 / 24
Fig. 5-3-2-1-2
Fig. 5-3-2-1-4
[3] Check that M5 Square nut is inserted into Motor
housing.
M5 Square nut
M5 Square nut