Making Connections For Viewing Images To Be Printed - Sony UP-51MDP Instructions For Use Manual

a) This selector is supplied with models other than UP-51MDU. Set the NTSC/PAL selector to your
b) Two kinds of 75-ohm termination switches are provided; one is for the RGB input and the other is

Making Connections for Viewing Images to be Printed

Connect a video monitor to view stored images and to check those to be printed.
Connect the required video monitor which will be used in actual printing, using the
following diagram as a guide.
Before connecting the video equipment, see "Important safeguards/notices for use
in the medical environments" for UP-51MD/51MDU/51MDP on page 2.
b)
to RGB/SYNC OUTPUT
75-ohm coaxial
cable with BNC
connectors
a) This selector is supplied with models other than UP-51MDU. Set the NTSC/PAL selector to your
b) See "When connecting the video monitor to the RGB SYNC OUTPUT connectors" on the next
TV system. To switch the TV system, turn the power off once, then change the setting. If you
change the setting with the power on, this mode will not be switched.
for the composite video signal. Normally set this switch to ON. Set it to OFF if the level of the
input signal drops because the signal is divided to additional video equipment other than the
printer.
NTSC/PAL selector
to VIDEO OUTPUT
to S-VIDEO
OUTPUT
Connecting cable (with
DIN 4-pin connectors)
YC-15EV
to S-VIDEO
input
connector
to RGB input
connectors
TV system. To switch the TV system, turn the power off once, then change the setting. If you
change the setting with the power on, this mode will not be switched.
page.
a)
NTSC PAL
to AC IN
75-ohm coaxial
cable with BNC
connectors
to composite
AC power cord
video input
(supplied)
connector
Video monitor
Installation and Adjustment
to wall outlet
75