Connections; Making Connections For Capturing Video Images - Sony UP-51MDP Instructions For Use Manual

Connections

Making Connections for Capturing Video Images

75-ohm coaxial cable with the BNC connectors
to RGB/SYNC INPUT
74
Installation and Adjustment
To enable printing, video equipment to act as an input signal source, and a video
monitor to display images or menus must be connected.
The following diagrams illustrate how to make the input, output and remote control
connections. Use this as a guide when connecting the required signals to and from
the equipment to be used for printing.
Notes
• Turn off the power of each device before attempting to make any connections.
• Connect the AC power cord last.
Connect the video equipment providing the video images to be printed.
Connect the video equipment which will be used in actual printing, using the
following diagram as a guide.
Before connecting the video equipment, see "Important safeguards/notices for use
in the medical environments" for UP-51MD/51MDU/51MDP on page 2.
Video equipment
to RGB output connectors
Connecting cable (with DIN 4-pin connectors) YC-15EV
to S-
VIDEO 75-ohm coaxial cable with the BNC connectors
INPUT
to VIDEO INPUT
NTSC/PAL selector
75-ohm termination
switch b)
ON
OFF
to S-VIDEO
output
connector
a)
NTSC PAL
AC power cord
(supplied)
to composite video
output connector
to AC IN
to wall outlet