Preparing The Remote Control Unit - Sony UP-51MDP Instructions For Use Manual

Preparing the Remote Control Unit

Using the RM-5500 remote control unit
Using the RM-91/FS-30/FS-36
The following remote control units (not supplied) allow you to control the printer
remotely.
• RM-5500 Remote Control Unit: Used to connect to the REMOTE 1 connector
• RM-91 Remote Control Unit and FS-36 Foot switch: Used to connect to the
REMOTE 2 connector.
• FS-30 Foot switch: Used to connect to the REMOTE 3 connector.
The RM-5500 Remote Control Unit can be used either as a wireless or wired type.
The buttons on the remote control unit duplicate those on the front panel of the
printer. (See "Main Panel" on page 135 and "Sub Panel" on page 136.)
You can use the remote control unit's buttons which have the same names as those
on the printer.
To use the RM-5500 remote control unit (not supplied) as a wireless
unit
When using the remote control unit as a wireless unit, aim the head of the remote
control unit at the remote sensor on the printer. With fresh batteries, the range of
the remote control unit is about 3 meters.
The operations to be remotely controlled by the RM-91 remote control unit or the
FS-30 foot switch depend on the remote operation settings made with the
FUNCTION SETUP menu. ("Selecting the Operating Mode for Automatic Printing
Capabilities" on page 104.)
FS-36 (not supplied) has three switches that have different functions.
For detailed information on how to use those switches, refer to the manual supplied
with the FS-36.
Installation and Adjustment
73