Table of Contents
Advertisement
CLIF-CBUSLC INTERFACE – INSTALLATION & COMMISSIONING INSTRUCTIONS
USB 2.0 Host Interface
Fig. 5. USB 2.0 Host interface
USB 2.0 Device Interface
The CLIF-CBUSLC is equipped with a USB 2.0 Device Inter-
face at the front. This interface is for connection to a web
browser for setting up the device.
Fig. 6. USB 2.0 Device Interface
A standard USB type-B connector can be inserted into this
USB 2.0 Device Interface.
NOTE:
Before attempting to connect a web browser to the
USB 2.0 Device Interface of the CLIF-CBUSLC,
you must first install the USB Driver on your PC.
See following section "USB Driver Installation".
EN1Z-1026GE51 R0417
USB 2.0 Device Interface
USB Driver Installation
Windows 7
In order to connect the CLIF-CBUS Interface to the Windows
7 PC, you will need an USB cable of type A-Male-to-type-B-
Male (Type B standard).
The CLIF-CBUS Interface will be connected to the Windows 7
PC as shown in the following figure.
CLIF-CBUSLC #2
CLIF-CBUSLC #1
Driver Variants
Depending on the firmware version, there are two different
ways to install the USB driver.
1.
On most PCs, the update is done automatically with the
Windows update function.
2.
In the case of firmware 4.00.00 or higher, you can use
the Microsoft driver from your Windows 7 installation
(procedure then starts with step 17 of the following
Procedure).
PROCEDURE
1.
Insert the A Male connector of the USB cable into an
USB inferface jack of the PC and insert the B Male con-
nector into the controller's USB device interface jack.
RESULT:
The Found New Hardware Wizard is
enabled in the Windows Task Line.
2.
In the Windows Task Line, double-click the icon.
RESULT:
The Driver Software Installation message
box displays.
3.
If no RNDIS/Ethernet Gadget driver was found as
indicated by the message "X No driver found", click the
Change setting... button.
RESULT:
The Device Installation Settings dialog box
displays.
6
WINDOWS 7 PC
Hide quick links:
Advertisement
Table of Contents
