Bosch Solution 2000 Quick Start Manual

Alphanumeric
LCD
Solution 2000/3000
Master Code Default [2] [5] [8] [0]
1
Show Fault/Trouble
Condition
• Main screen > press & hold [5].
• Use arrows to scroll & [-] to
exit.
6
Program Zone Type
• Installer Code then [-].
• Select Menu [4] [1] (Zone
Config).
• Select zone number > scroll
with arrows or enter zone
number, then [#].
• Select zone type > scroll with
arrows or enter zone type,
then [#].
• Repeat for other zones.
• Press [-] until 'Confirm to
Save Parameter Changes'
appears then [#].
7 Program Primary
Receiver
• Installer Code then [-].
• Select Menu [7] [1] [1] (First
Phone Number).
• [#] to select Receiver 1.
• Enter phone number using
number keys, then [#].
• Press [-] until 'Confirm to Save
Parameter Changes' appears
then [#].
Communicator Format Types
0 – Not Used
1 – Contact ID
4 – Domestic Dial
8 – CSV-IP
9 – Email
Codepad (Menu Programming)
2
Default the Panel
• Remove power (PSU & battery).
• Press & hold DEFAULT button
on PCB while reconnecting
power.
5 Enter Installer Menu &
Change Installer Code
• Installer Code then [-].
• Select Menu [2] [1] (Installer
Code).
• Enter new Installer Code, [#].
• Press [-] until 'Confirm to Save
Parameter Changes' appears
then [#].
Common Zone Types
0 – Instant; 1 – Handover; 2 – Delay 1; 3 – Delay 2; 11 – Keyswitch;
12 – 24hr Burglary; 14 – Chime Only; 15 – Not Used
Program Secondary
8
Receiver
• Installer Code then [-].
• Select Menu [7] [1] [2]
(Second Phone Number).
• [#] to select Receiver 1.
• Enter phone number using
number keys, then [#].
• Press [-] until 'Confirm to
Save Parameter Changes'
appears then [#].
10
Program Communicator Format
• Installer Code then [-].
• Select Menu [7] [1] [3] (Transmit Format).
• [#] to select Receiver 1.
• Select format > scroll with arrows or enter format type then [#].
• Press [-] until 'Confirm to Save Parameter Changes' appears
then [#].
Installer Code Default [1] [2] [3] [4]
3
• Main screen > Master Code
then [6] [#]
• Enter Date & Time using
number keys
• [#] to save or [*] to exit
4
• Master Code then [-]
• Select Menu [2] [2] (User
Code). [#] to select U01 –
User 01 Name.
• Enter new Master Code, [#].
• Press [-] until 'Confirm to Save
Parameter Changes' appears
then [#].
9
• Installer Code then [-].
• Select Menu [7] [1] [4]
(Subscriber ID Number).
• [#] to select Receiver 1.
• Enter account code using
number keys, then [#].
• Press [-] until 'Confirm to Save
Parameter Changes' appears
then [#].
Set the System
Time & Date
Change the
Master Code
Program System
Account Code