Advertisement
W
iring diagram
[2] Wiring in Handle for 4114
[3] Wiring in Handle for 4114S
Avoid this pin to route
the lead wires of Power
supply cord.
Pin
Put Noise suppressor
in this space if used.
Connecting Insulated Receptacles
with Terminals of Switch
Be sure to connect so that all slits
of the four Insulated receptacles
face the same direction as illustrated
below.
[Correct]
Switch
Terminal of Switch
Put Noise suppressor
in this space if used.
Switch
Do not put the lead wires
of Power supply cord on
this rib.
Insulated receptacle
Rib
Switch
Put Soft start circuit
in this space.
Insulated receptacle
(viewed from the wheel installation side)
Insulator
Terminal
[Wrong]
Fix the following lead wires
with this lead wire holder:
*2 Field lead wires (black)
*Lead wire of Soft start circuit (white)
*Lead wire of Soft start circuit (orange or red)
Fix the following lead wires with this lead
wire holder, and put in this space:
*2 Field lead wires (purple, orange)
*2 Connecting lead wires (purple, orange)
from Brush holder
Fix the following lead wires
with this lead wire holder:
*2 Field lead wires (black)
*Lead wire of Soft start circuit (white)
*Lead wire of Soft start circuit (orange or red)
Fix the following lead wires with this lead
wire holder, and put in this space:
*2 Field lead wires (purple, orange)
*2 Connecting lead wires (purple, orange)
from Brush holder
Slit in Terminal
P 6 / 6
If Line filter is used,
guide two Field lead
wires (black) through it,
and put in this space.
Advertisement
