Avc Setting - Honeywell X-618 Commissioning Manual

Figure 16 Amplifier Channel Settings window
2. Set the parameters as you need.

Select the Model, and its Power and Channel number will show after it.

Enable/disable the Standby Amplifier to determine the channel is the master channel or
standby channel.

Auto-recovery is used to enable/disable the master amplifier to recover from the standby
amplifier automatically, after the master amplifier becomes normal.

Channel (CH1, CH2, CH3, CH4) is used to select the standby amplifier corresponding to the
master amplifier.
3. Click OK button to complete the setting for the amplifier.

AVC Setting

The AVC Setting function allows you to set the parameters for the four AVC channels.
To set the AVC parameters:
1. Click the AVC Setting on the sub-system area on the right of the window as shown in the
Figure 7, the AVC Settings window displays as shown in the Figure 17.
Figure 17 AVC Setting Window
2. Set the parameters as you need.

Volume Up Time

Noise response level

Sensor drift indicators

Signal level offset (min.)
18