Honeywell X-618 Commissioning Manual page 35

Figure 29 NPM Settings Window
4. Set the parameters in the Device Setting area as you need.

Device ID

Device description

Button trigger mode
Press Mode: the user needs to press the TALK button during the speaking, or not, the
selected zone is released with ending the speaking.
Toggle Mode: the user only need to press the TALK button and start the speaking, and press
it again to release the selected zone and end the speaking.
5. Set the parameters in the Network Setting area.

IP address

Subnet Mask

Default gateway
6. Set the parameters in the Call Setting area.

Microphone EME priority

Microphone TALK priority

NPM Multicast Address
7. Set the play tasks for each zone in the Play Tasks area.

Priority

Dry Contact Enable

Dry Contact ID

Playlist

Turn on Delay

Volume

Loop

Interrupt Recovery

Play Full

Busy Wait
8. Select the DCS in the DCS List.
29