Configuring The Digital Telephone For The Correct Number Of Line Keys; Figure 5-51 Installing The Line Key Panel - NEC Univerge SV9100 System Hardware Manual

Issue 2.0
SV9100 System Hardware Manual
9. Install the supplied Line Key Panel (refer to
Line Key
button LK Panels (refer to Chapter 1,
Equipment List on page

Figure 5-51 Installing the Line Key Panel

10. Install the side panel.
11. Connect the line cord/LAN cable and the AC/DC adapter to the
DTL/ITL multiline terminal.
4.5.2 Configuring the Digital Telephone for the Correct Number of
Line Keys
1. With the telephone not plugged in and the handset on-hook, press the
4 and 6 buttons on the numbered keypad and connect the telephone
cable.
 This places the telephone into Service Class Read/Write (R/W)
mode. The Message Waiting (MW) LED should be On.
2. Press 1 to enter the Line Key Type mode.
 The Message Waiting LED should flash.
Panel). A variety of colors is now available for the 12 and 24
1-13).
Figure 5-51 Installing the
Table 1-10 SV9100 Optional
Line Key
Panel
5-57