Table of Contents
Advertisement
Installation & User's Manual
CLEANING AND CARE
WARNING! All cleaning should be performed with power completely removed from the luminaire. Never remove
protective covers when luminaire is powered. Wear appropriate protective eye wear and gloves when cleaning the
fixture. All service and maintenance, other than described herein, should be performed by a qualified technician or
Authorized Service Center.
1. Special Cleaning and Care Instructions
Being a solid-state fixture, and unlike most fixtures, the PLPROFILE4 LED Luminaire requires very little routine
maintenance by the user. This section covers portions of the luminaire that can be removed for cleaning.
The PLPROFILE4 LED Luminaire requires special care when it comes to cleaning front lens assembly. Additional
care needs to be taken with the plastic components because they are much easier to scratch or damage than glass.
The following is a list of cleaning materials required to care for your PLPROFILE4 LED Luminaire:
• Lint free lens tissue
• Lint or powder free gloves
• Reagent grade isopropyl alcohol*
• A mild soap solution.
Note: *Reagent grade isopropyl alcohol is good to use on the PLPROFILE4 LED Luminaire plastic optics with anti-
reflection coatings.
If the lens is still dirty after using isopropyl alcohol, for instance if fingerprints or oil is just redistributed and not
cleaned off the optic, then a mild soap and water solution can be used to gently wash the lens. Repeat the cleaning
with isopropyl alcohol to eliminate streaks and soap residue.
WARNING! Under no circumstances should ammonia-based cleaners, acetone, or other harsh solvents be used on or
near the PLPROFILE4 LED Luminaire. These types of cleaners or solvents can permanently damage the optics or
housings of the fixture.
If you have any questions regarding the use or care of your PLPROFILE4 LED Luminaire, please contact Philips
Selecon technical support or your local Authorized Dealer.
2. Lens Cleaning
Front Lens (Exterior)
To clean the exterior front lens:
Step 1. Turn off luminaire and allow to cool completely.
Step 2. Apply a small amount of reagent grade isopropyl alcohol to lint-free lens tissue.
Step 3. Wipe all debris, dirt, fingerprints, etc. from lens.
Step 4. Using a second lint-free lens tissue, wipe off any alcohol residue.
Front Lens (Interior)
To clean the interior of front lens:
Step 1. Turn off luminaire and allow to cool completely.
Step 2. Place luminaire on a flat, clean surface. Be careful not to scratch or damage luminaire.
Note: A long 3 mm Allen hex key is required to perform this procedure.
3 6
CLEANING AND CARE
PLPROFILE4 LED Luminaires
Advertisement
Table of Contents
