Table of Contents
Advertisement
PLPROFILE4 LED Luminaires
3. Beam Shutter Operation
Each PLPROFILE4 LED Luminaire is equipped with four independent shutters (as shown in Figure 8) to block or
shape light as desired. After the luminaire is installed and positioned, move the shutters in or out as required. Use the
shutter lock to lock-in the shutter settings.
Beam Shutters
(4 Each)
Shutter Lock
4. Gobo/Iris Access Panel
Each PLPROFILE4 LED Luminaire is capable of holding two gobo holders, each containing one "B" sized glass or
steel gobo. PLPROFILE4 LED Luminaire are not supplied gobo holders or an iris. These items can be purchased
from your local Authorized Dealer. For more information, refer to
on page
5.
To install or change a gobo:
Step 1. As shown in Figure 9 on page 16, loosen, but do not remove, two retaining screws that secure gobo/iris
access panel. Slide open gobo/iris access panel.
Step 2. Install gobo into gobo holder in desired orientation.
Step 3. Slide gobo holder into luminaire gobo slot.
Step 4. Close gobo access door. Make sure gobo holder handle fits inside one of two slots in gobo access panel.
See Detail
Shutter Lock Detail
Shutter Lock
Figure 8: PLPROFILE4 LED Luminaire Beam Shutters
Installation & User's Manual
Move beam shutters
in and out as desired.
Front View
"PLPROFILE4 LED Luminaire Lens Accessories"
Beam Shutter Operation
15
Advertisement
Table of Contents
