Accenta/Optima Engineer's Manual
3 = Inhibit Zones
This is a zone which, on setting the panel, allows access to the entry/exit zone. However, if the panel is set and
a time inhibited zone is triggered before an entry/exit timed zone then an alarm will be generated immediately.
LCD Keypad:
NOTE:
Pressing the number toggles the zone ON or OFF
While in Engineer program mode, to set up zones as inhibit,
•
Press
to give a choice of programs or press
P>Programs is displayed then press
•
Select program 1, 2 or 3.
•
The first screen to appear is Program Edit Used Zones.
•
Press [3] to enter into Inhibit Zones. The first zone can now
be set as inhibited or uninhibited.
•
To edit the other zones press [Number] or
particular zone.
•
Press
three times to leave menu.
LED Keypad:
NOTE:
Pressing the number toggles the zone ON or OFF
While in Engineer program mode, to set up zones as inhibited,
•
Press
to give a choice of programs. LED's 1, 2 and 3 are
flashing.
•
Select program [1, 2 or 3]. If program 1 is selected, LED 1 is ON.
•
Press [3] to enter into Inhibit Zones. The first zone can now be
set as inhibited or uninhibited.
•
To edit the other zones press [Number] to go to a particular zone.
Default settings are shown opposite.
•
Press
three times to leave menu.
until
.
to go to a
37
Programs (contd)
P>Select Program
1 2 or 3
[Number]
P>Program Edit
Used Zones
[3]
1: Descriptor
Inhibit:
[Number] or
2: Descriptor
Inhibit:
P>Programs
4
5
1
2
3
[1]
1
2
3
4
5
[3]
1
2
3
4
5
[Number]
4
5
1
2
3
3
4
5
1
2
YES
NO
7
8
6
6
7
8
6
7
8
7
8
6
6
7
8